ENSONIQ ASR-X PRO, User Manual

Page: 40 / 74

Insert Effect Parameters
32 ENSONIQ ASR-X Pro UserÕs Guide
11
1 1000 0 SSSStttteeeerrrreeeeoooo C
C
C Chhhhoooorrrruuuussss
This stereo chorus uses delays to produce pitch and amplitude modulation.
PPP Paaaarrrraaaam m m meeeetttteeeerrrr RRR Raaaannnnggggeeee D D D Deeeessssccccrrrriiiippppttttiiiioooonnnn
LFO Rate 0.0Hz to 20.0Hz Controls the rate of pitch modulation applied to the
delays.
Chorus Depth 0.0ms to 25.0ms Controls the excursion of modulation. As this parameter
increases, the amount of detuning also increases.
ChorusCenter 0.0ms to 50.0ms Controls the nominal delay time of the chorus about
which the delay modulation occurs. Adjusting this
parameter will change the tonal character of the chorus.
Spread (wide stereo to mono, to
reversed image)
Offers control of the synthesized stereo field. The
farthest counterclockwise setting of the Value knob
offers true stereo, the middle setting forces the left &
right into the center (mono), and turning the Value knob
fully clockwise inverts the left & right signal.
Chorus Phase 0deg or -180deg Controls the relative phase between left and right LFOs.
11
1 1111 1 888 8----VVV VooooiiiicccceeeeC
C
C Chhhhoooorrrruuuussss
8-Voice Chorus offers a symphonic chorused sound having eight different voices and using eight
separately randomized LFOs. This effect is good for creating an ensemble of instruments from single
sources (there is no internal filtering applied to any of the chorused voices).
PPP Paaaarrrraaaam m m meeeetttteeeerrrr RRR Raaaannnnggggeeee D D D Deeeessssccccrrrriiiippppttttiiiioooonnnn
EQ Input Off, -49.5dB to +24dB Adjusts the input volume of the EQs to eliminate the
possibility of clipping boosted signals.
Mid 1 Fc 10Hz to 20.0kHz Sets the center of the mid frequency band.
Mid 1 Q 1.0 to 40.0 Bandwidth control that determines the width of the
resonant peak at the center frequency band. This
parameter is equal to the cutoff frequency divided by
the bandwidth. Raising the value will produce a
narrower bandwidth.
Mid 1 Gain Off, -49.5dB to +24dB Sets the amount of boost or cut applied to this mid
frequency band.
EQ Output Off, -49.5dB to +24dB Controls the gain coming out of the parametric EQ.
Dry Blend Full Dry to Full Wet Controls the dry to wet mix of the chorus .
HPF Cutoff 10Hz to 10.9kHz Controls the cutoff frequency of the high pass filter
frequency applied to the input signal.
LFO Rate 0.0Hz to 7.0Hz Controls the rate of pitch modulation applied to the
delays.
Chorus Depth 0.0ms to 300ms Controls the excursion of modulation.
ChorusCenter 0.0ms to 300.0ms Controls the nominal delay time of the chorus about
which the delay modulation occurs. Adjusting this
parameter will change the tonal character of the chorus.
Center Offset 0% to 100% Controls the relative spacing in nominal delay time
among the eight voices. 100% is the maximum setting.
Chorus Phase -180deg to +180deg Controls the relative phase between left and right LFOs.
Chorus
Feedback
-99% to +99% Controls the amount of feedback applied to the chorus.
Positive settings are in-phase, negative values are out-
of-phase, and impart a different tonality to the chorus.