The safety of this crusher is valid only if there i san user’s electrical system complies with the law
regulations in force and that its maximum power absorption is taken into
If it is necessary to use extension or multi-socket , use only material conformed to the law
regulation in force and respect the limit of maximum power absorption. We suggest to use a cord
wide 1,5 mm for extension till 20mt, and wide 2,5 for longer distance
8. START-UP
Important: before starting the machine, ensure that there is nothing that prevents the mechanical
parts from moving freely and, above all, that nobody is close to the moving parts of the machine.
More specifically, hands, arms and other body parts must be kept well away from the stalk outlet
opening and from the inside of the box.
Ensure that the engine voltage corresponds to the voltage of the mains.
.
If during this control there is a defect , stop the crusher, disconnect the plug by the main, advice the
dealer or directly Enoitalia srl
To start the machine, proceed with the electrical connection which must be carried out by a
qualified technician. Avoid wetting the plug and socket.
To start the machine press the start button, to stop it press the red emergency button (figure 3).
Once the red emergency button has been press, to start the machine again rotate this button in the
direction indicated by the arrow.
Once start-up has been completed, place the grapes inside the loading hopper and set the destalking
speed) by using the wheel located on the speed-adjustment drive unit (
do not use the wheel of the
speed-adjustment drive unit when the engine is off as this would cause the wheel to break
).
By using this wheel the rotation speed of the destalking shaft is adjusted thereby allowing a more or
less gentle destalking.
The amount of bunches to be destalked depends on the screw feeder on the hopper and cannot be
changed by pushing the bunches through the inlet (
this operation is of no use and should not be
carried out as it is extremely dangerous
).
Should a self-priming pump be used, fit the collection tray before starting the machine. Make sure
this is secured.
Should it be necessary to access the inside of the machine (in case of blockages or foreign bodies),
proceed as follows:-
1.
Turn off and unplug the machine.
2.
Remove item from the inside of the machine by using a suitable tool and if necessary open
the machine.
3.
Close any open parts and repeat all start up operations.
During machine operation the user must check that there are no skins or berries still attached to the
stalks at the outlet, and that there are not too many stalk fragments inside the berries collection tank.
If there are stalks inside the tank, usually all that is required is to reduce the speed. If berries are still
attached to the stalk at the outlet, increase the speed.
Finding the correct speed depends largely on the experience of the user as he shall have to adjust it
depending on the type of grapes, on their degree of ripeness and on the type of processing these will
subsequently undergo.
Do not carry out introduction of body part or instruments, or maintenance work
while the machine is in operation
