To crush or top cut
hamr and fingers
Hopper screw
Don’t remove the safety protection
Stop the machine and disconnect the motor’s plug by the net before to start
any repair or maintenance.
Don’t repair the machine while it is working
To crush leg and
feet
Fall down of the
machine
Use safety shoes
Be sure of the installation of the machine
Electrocution.
Fire
Engine
It is important that the user’s electrical system complies with the law
regulations in force and that its maximum power absorption is taken
into account
Check the cord and the plug if they are new and good
Prevention of humidity
Only specialized person have to work on the electrical panel
TAB. 1: general risk
6. INSTALLATION
Check that the machine is complete, perfect and there are no evident defect. Advice immediately
the company Enoitalia srl in 15 day, about all the defects
Lift the machine as indicated in the figure.
To take the machine it is possible to use automatic lift system: be sure to balance the
weight.
Transport the machine to the place it is to be installed in and ensure that all the wheels rest perfectly
on the ground. Block the front wheels with the brakes provided (figure 1 n°2).
Remove machine from packaging and dispose of the latter in compliance with law regulations.
Make sure the floor on which the machine is to be positioned can withstand the machine’s full
capacity weight and that it is not inclined by more than 10%. Wash machine thoroughly to eliminate
any residue and any dust on its surface.
To wash the machine, proceed as follows:-
1.
Open machine cover by unscrewing the two screw fastenings and by lifting it with the handle
provided.
2.
Remove the stalk outlet protection by unscrewing the four screw fastenings.
3.
Remove the shaker and the basket. Remove shaker shaft by turning it anticlockwise.
4.
Release rollers and open the crushing unit.
5.
Wash machine carefully avoiding to wet the electrical parts
6.
Close the machine once washing is completed.
7.
Install the anti-accident box.
7 WIRING CONNECTION
To start the machine, proceed with the electrical connection which must be carried out by a
qualified technician. Avoid wetting the plug and socket.
Check the label on the motor and the adequancy with user’s electrical system
