ENIGMA XM88422 Digital Receiver
Version 1.50
16
The Menu
By pressing the Menu button the menu is started.
Through the menu, the utility and local programming
functions can be accessed. The menu starts at the
main menu bar in the top of the screen.
Navigation in Menu
To navigate through the menu options the directional
buttons can be used. To enter a submenu or select a
menu item, press the Enter/Ack key. To step back
press Clr. Pressing Clr at the main menu bar will exit
the menu mode. The menu structure can be found in
the Appendix A.
WARNING:
When the menu is active it has priority
over the incoming event messages. Exit the menu
immediately after the necessary changes have been
made to the receiver program to avoid unwanted
delay in message display.
Utilities and Local Programming
Through the menu, it is possible to access receiver
utility and local programming options. The available
commands are shown in the menu structure
Resend Events
The receiver stores the last 4096 events in the
memory even after it had reported to the computer or
printed. The Resend Events command will force the
receiver to send the contents of the memory buffer to
the central station computer regardless that the
events were reported before or not. (Memory flush)
Reprint Events
This command works the same way as the Resend
Events command, except that it sends the contents of
the memory buffer to the printer.
Receiver Status
This command will display receiver status in a dialog
box. The receiver status display can also be
accessed by pressing the Info button in normal
operating mode. The contents of the dialog box are
detailed in the System Status Information section
before.
Reset Receiver
This utility command allows the central station
operator to make a full receiver reset. This can be
useful if receiver malfunctions encountered. The
Reset Receiver command will make a warm-reset of
the receiver and will not change or destroy the
contents of the memory buffer and the user defined
libraries.
Erase Memory
This command is also can be used to reset the
receiver, but this command makes cold-boot, which
means, that the full power-on self-check sequence
will be executed and the contents of the memory will
be cleared. The user defined libraries will also be
destroyed, and have to be downloaded again.
Factory Default
This command makes a cold-boot with the factory
default parameters restored in the configuration
EEPROM. Use this command to reset the receiver to
the factory default state.
WARNING:
Use the Erase Memory and Factory
Default commands with extreme caution because
these commands will erase the contents of the
memory buffer that may result data loss.
Date & Time
The real time clock of the CPM Unit can be set at this
option. A dialog box appears when selecting the
menu item:
Date: 98/06/20
Time: 15:25:10
The currently selected field is flashing. Skip between
fields with the Left and Right buttons. The field
contents can be increased with the Up button and
decreased with the Down button. Pressing the
buttons continuously will repeat the action until the
button is released. After the time and date is set
correctly, press the Enter/Ack key to save the set
v
alues. A “Time/Date Set” event will be recorded.
Pressing the Clr button will exit the dialog box without
making any changes.
CPM Options
The programmable options of the CPM Unit can be
set at the CPM Options section of the menu. A dialog
box will appear with the following:
Receiver Number: 001
Heartbeat : 030
Clock Signal : OFF - S
Printer Mode : BACKUP
External Ack : ENABLE
Tamper Check : DISABLE
Buzzer Mute : DISABLE
Hotswap Mode : DISABLE
LCD Contrast : 8
The currently selected field is flashing. Skip between
fields with the Left and Right buttons. The field
contents can be increased with the Up button and
decreased with the Down button. Pressing a button
continuously will repeat the action until the button is
released. After the fields are set correctly, press the
Summary of Contents for XM88422
Page 1: ...User Manual ...
