ENFORCER RINS1708-3, Installation & Reference Manual

Page: 6 / 24

Page:
6
3.4 Connecting / Replacing the Control Panel Battery
1 . Unscrew the battery
compartment
2 . Connect the batteries 3 . Close the battery
compartment masking sure no
battery cable is trapped
underneath.
NOTE : The Enforcer 32-WE back up battery must be replaced by the
manufacturer’s recommendation. The part code for this battery is BATT9V6/2Ah1-
WE.
The battery is a NiMH 8 cell 2200mAh rechargeable.
Install the batteries in the space provided and connect the battery connector to the
two pins as shown above. Reinstall the battery holder cover
Dispose of the batteries in accordance with the local regulations.
3.5 Important Installation Notes
 Ensure wiring is done to the national wiring regulations in the country where the installation is
taking place. In the UK, this is ‘BS 7671 -Requirements for electrical installations; IET Wiring
Regulations (17th edition)’. If in doubt, consult a qualified local electrician.
 Ensure that a readily accessible disconnect device is incorporated in the premises installation wiring
and is provided external to the equipment with a contact separation of at least 3,0mm and
connected as closely as possible to the supply.
 Ensure that the Input and Output Board (I/O Board) used to connect wired keypads, readers,
inputs and outputs to the Enforcer 32-WE, is only connected to circuits operating at SELV voltage.
 When securing external wires, ensure that means are provided in the installation to prevent the
SELV or signal circuits from coming into contact with live parts of the power supply circuit. Wires
should be fixed near their terminal blocks.
 The end of the stranded conductor shall not be consolidated by soft soldering at places where the
conductor is subjected to contact pressure.
 On completion of wiring use tie-wraps to prevent any loose wires causing a safety hazard (material
of cables ties shall be rated at least HB or better).
 Cables ties and hoses shall be separate for power supply cable and SELV wirings.
 Size of protective bonding conductors: minimum section 1.5mm².