Page:
4
3.
Initial Power Up
NOTE 1:
It is recommended that the Engineer menu is accessed prior to opening a powered Enforcer 32-
WE.
NOTE 2
: If any new peripheral is installed (i.e. Modem, I/O board, Expander) it is recommended that the
Enforcer 32-WE is powered down (mains and battery).
1.
Slightly unscrew the two
screws located at the bottom.
NOTE:
Do not fully unscrew -as
these can be used as a 'hanger'
to the rear casing as shown in
Step 3.
2.
Unhinge the Enforcer 32-WE
from the top and pull down to
disconnect.
NOTE:
Take extra care when
removing the front of the Enforcer
32-WE as modems, I/O boards
etc may be connected to the
front.
3.
Rotate the front of the
Enforcer 32-WE 180 degrees and
hang it on the opening screws if
required.
3.1
Mains and Earth Wiring
It is important that the electrical earth connection is connected when connecting the 230V mains
supply to the Enforcer.
NOTE 1:
Do not locate the mains cables next to internal cabling.
NOTE 2:
Ensure that the Enforcer 32-WE is not mounted on any metal surfaces.
NOTE 3:
Mains cables should not be internally 'looped' or tightly bundled as this may interfere with
the wireless antennas. Where possible it is recommended that all mains cables should be installed
through the area nearest the mains terminals as shown above.
Summary of Contents for RINS1708-3
Page 23: ...Page 23 8 NOTES...
