ENFORCER RINS1708-3, Installation & Reference Manual

Page: 5 / 24

Page:
5
3.2 Inside of the Enforcer 32-WE: Rear
1. Terminals for Earth and Mains Supply. See page: 4.
2. If a modem is required (DIGI-GPRS, DIGI-LAN or
DIGI-1200/PSTN) then this space is used to install
them. See page: 19
3. The transformer is situated in a housing, this
shouldn’t need to be removed.
4. The rear tamper adjustment screw is used if the
tamper from the front of the Enforcer 32-WE isn't sitting
flush to the back plate - this may happen if the Enforcer
32-WE is installed on an uneven surface.
5. If an I/O board is installed, then this space is used to
install it. See page: 9.
3.3 Inside of the Enforcer 32-WE: Front
1. RS232 connection for Up/downloading to the
InSite software. See page: 17
2. The location of the control panel battery.
See page 6 for replacement procedure.
3. The power connection for a DIGI-GPRS if
connected (Note that this port is labeled ‘GSM
MODEM’). See page: 19
4. The connection for an I/O board if
connected. See page: 9.
5: The connection for the modem installed
(DIGI-GPRS, DIGI-LAN or DIGI-1200/PSTN).
See page: 19
6: The power connection (+12V DC) for the
Enforcer 32-WE.