EK-Pak Owner and Installation Manual
EK-Pak Owner & Installation Manual First Edition December 2002
3
FOR YOUR SAFETY READ BEFORE OPERATING
A. This burner does not have a pilot. It
is equipped with an ignition device
which automatically lights the
burner. Do not try to light the burner
by hand.
C. Use only your hand to turn the installer
supplied
Manual Gas Shut Off Valve.
If
the valve will not turn by hand, don’t try to
repair it, call a qualified service technician.
Force or attempted repair may result in a
fire or explosion.
B.
Before OPERATING, smell all
around the heating module area for
gas. Be sure to smell next to the
floor because some gas is heavier
than air and will settle on the floor.
See below.
D. Do not use this heating module if any part
has been under water. Immediately call a
qualified service technician to inspect the
heating module and to replace any part of
the control system and any gas control,
which has been under water.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building
•
Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
OPERATING INSTRUCTIONS
1.
STOP!
Read the safety information above.
2. Set the thermostat(s) to their lowest setting.
3. Turn off all electrical power to the burner/heating module.
4. This burner is equipped with an ignition device which automatically lights the
burner.
5. Do not try to light the burner by hand.
6. Actuate installer supplied
Manual Gas Shut Off Valve
located outside the unit to
the
OFF
position.
7. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the
floor. If you smell gas,
STOP!
Follow the safety information above. If you don’t
smell gas, go to the next step.
8. Actuate installer supplied
Manual Gas Shut Off Valve
located outside of the unit to
the
ON
position.
9. Set thermostat(s) to desired setting.
10. Turn on all electric power to the burner and heating module.
11.
If the burner/heating module will not operate, follow the instructions
“TO TURN
OFF GAS TO THE BURNER”
below and call your service technician or gas
supplier.
TO TURN OFF GAS TO THE BURNER
1. Set thermostat(s) to their lowest setting.
2. Turn off all electric power to the burner and heating module if service is to be
performed.
3. Actuate the installer supplied
Manual Gas Shut Off Valve
to the OFF position. Do
not force.
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
