Energer ENB540DBT, Instructions Manual

Page: 13 / 33

13
Fitting the column
Align the three threaded holes on the
base plate(7) with the column(5) support holes.
Secure with the three bolts.
Do not over tighten as this could crack the cast
base plate(7) and column(5) support(Fig.3).
Fitting the table
Lower the table assembly onto the column(5). The
assembly will slide easily into position so do not use
O
force. Make sure the table assembly will rotate 360
Tighten the support lock to secure the table assembly
into position
. (Fig.4)
Before you start
Fig.3
Fig.4
GB
IE
Mounting the base plate
Select a suitable location for the drill on a
workbench. Be aware of table legs and
anything which might reduce access to
the underneath of the workbench. A suitable
mains supply socket must also be accessible
for the plug. Locate the base plate(7) in the
selected position. Select two suitable length
bolts, washers and nuts (not supplied).
Using the base plate
as a template drill (7)
two holes through the workbench.Bolt
the base plate
to the bench. Do not over (7)
tighten as this could crack the cast base plate . (Fig.2)
Fig.2
G
e
tt
in
g
s
ta
rt
e
d
..
.
ENB540DBT by ENERGER
7
5
5
8
6