Energer ENB540DBT, Instructions Manual

Page: 15 / 33

15
removal. Always return the guard(4) to cover rotating parts. Simply unscrew the
wing nuts and the two piece guard will extend vertically up or down. Chuck
guard(4) is adjustable to varying depths to give more protection(Fig.7-2).
Fitting the drill depth gauge
Remove the red pointer and uscrew M6
Nut from the bar
. Insert the bar into the
hole and the hole guard(4), located in chuck
Fitting the 3 jaw chuck
This machine is supplied with a Morse taper
stub shaft fitted into the spindle. To fit the
chuck(9), clean the protective film from the
chuck
internal taper and the stub shaft (9)
external taper with white spirit. Place the
chuck
onto the exposed stub shaft. Place (9)
a piece of wood onto the drill table. Using the
feed handles(3) lower the chuck
onto the (9)
wood.Gently apply pressure to engage the
taper and then let the spindle raise to its
upper position
. (Fig.9)
The drill is now fully assembled and secured
in position. The following adjustments and
setting up instruction must be carried out
before connecting the machine to the mains
supply.
Before you start
then screw the nut, assemble the red
pointer in the spindle(Fig.8).
GB
IE
Fig.8
Fig.9
Fig.10
G
e
tt
in
g
s
ta
rt
e
d
..
.
ENB540DBT by ENERGER
9