Energer ENB540DBT, Instructions Manual

Page: 20 / 33

Using a machine vice(vice not supplied)
WARNING: The drill should never be used
without the work piece being securely held in
a machine vice or clamped directly to the drill
table
. The drill table is designed to accept a (8) (8)
variety of machine vice which can be fastened
directly to the drill table
. Always secure the (8)
vice to the table with bolts, washers and nuts. (8)
If the drill jams into the work piece an
unsecured machine vice will spin out of
control causing the drill to snap and possibly
injure the operator
. (Fig.13)
Fig.13
Using the 3 jaw chuck
Select the drill bit required. Open the jaws and
insert the drill shank centrally into the
chuck(9).
Rotate the chuck by hand until the jaws (9) grip
the drill bit. The chuck has three holes (9)
around the chuck body. Locate the chuck key
and using an even torque move from each
hole location until all three holes have been
covered. Continue with the steady torque
until tight. Do not over tighten otherwise you
will have difficulty removing the drill bit
. (Fig.14)
Note: remove the chuck key before use.
Different drill bits and chisels can be used with this product depending
on the workpiece material and application required.
Fig.14
WARNING! Always use drill bits according to the intended use!
For example, never use a drill bit intended for working on wood for
working on stone or vice versa!
Observe the technical requirements of this product (see section
“Technical
specifications＂） when purchasing and using drill bits!
Some drill bits are very sharp and become hot during use!
Handle them carefully! Wear safety gloves when handling drill bits in
order to avoid injuries like burns and cuts!
In
m
o
re
d
e
ta
il
..
.
GB
IE
Product functions
ENB540DBT by ENERGER
20