Energer ENB540DBT, Instructions Manual

Page: 14 / 33

GB
IE
14
Fitting the head stock and motor
Locate the two grub screws in the side of the
head stock and motor assembly. Using a
hexagonal key slacken the two grub screws.
Lift the head stock and motor assembly and
lower it onto the column(. Make sure that it
slides down and locates fully on the column.
Position the head stock and motor assembly
ensuring it is aligned with the base plate(7).
Tighten the two grub screws to secure the
head stock and motor assembly into place(Fig.5).
Retain the hexagonal keys for future adjustments.
Fitting the hand feed handles
Locate and install the three hand feed handles(3).
Simply screw the handles
into the three (3)
threaded holes located in the feed shaft boss.
Make sure that all three handles
are tight . (3) (Fig.6)
Fitting the chuck guard
without the chuck guard(4) fitted.
The telescopic chuck guard is partially (4)
assembled onto the machine.
Remove three cross head screws just
below the hinge on the red collar.
Position the transparence plastic shield into the
red collar and secure in place with the three
small cross head screws
. The chuck (Fig.7-1)
guard (4) is spring loaded and on a hinge which
allows the guard to be moved upwards to (4)
expose the chuck for drill installation and (9)
Warning:never attempt to use the machine
Before you start
Fig.5
13
Fig.6
Fig.7-1
Fig.7-2
G
e
tt
in
g
s
ta
rt
e
d
..
.
ENB540DBT by ENERGER
3