63
Motion Detection
When the MMX detects any motion on the screen, it considers the motion as an event.
•
No.:
Select the desired cameras.
•
Sensitivity:
Set the motion sensitivity for daytime and nighttime independently.
•
Minimum Blocks for Detection
: Adjust the minimum number of detection blocks that must be activated to be
considered as a motion event for daytime and nighttime independently.
•
Event Action:
Click the field and the
Event Action Setup
screen appears.
Check the box for each action the MMX is to take when it detects a motion detection event.
− Alarm Out:
Select to trigger an alarm-output signal.
− Send Email:
Select to send an Email.
− Remote Callback:
Select to send a message to remote sites and select the desired remote sites.
− PTZ Preset:
Click the desired PTZ camera and select the desired preset number to move a PTZ camera to the
previously saved preset location. You must set up preset locations of PTZ cameras during the PTZ setup on the
DVR or by using the network keyboard.
•
Motion Ignoring Interval:
Select the motion ignoring dwell time from the drop-down list. The MMX will not log or
send notifications of motion events occurring during the preset interval range. You can control excessive event
logging and remote notifications of motion detection events by adjusting the motion ignoring dwell intervals.
•
Daytime:
Set up the daytime range. The MMX will consider the remaining time range as the nighttime.
NOTE: You must properly configure the settings related to each event action during the
5.4 Event – Event
Action
setup to enable event actions.
Summary of Contents for MMX
Page 1: ...Instruction Manual MMX Network Controlled Video Matrix System...
Page 77: ...77 Appendix 4 Map of Screens Remote Setup...
Page 78: ...78...
Page 79: ...79...
