66
Dynamic routing - from the other routing router from the other routing to reach the
target network to send the path, according to the changes in network structure to
dynamically update the routing information.
11.2Routing table configuration
Configure the routing function on the Layer 3 switch. You must enable the routing
function. Otherwise, the Layer 3 switch function is equivalent to Layer 2 switches.
Enter the [Routing Interface] - [Routing Configuration] menu bar. In the port routing
configuration page, you can select the dynamic RTP route to enable the Layer 3 switch
function, set the target network, subnet mask, next hop Address, Network Interface Click
the <Configure> button to modify the settings. After setting, click the <Save & Enable Layer
3 Forward> button at the bottom of the page to save the configuration. As shown below:
The interface item is described as follows:
Interface item
Description
Dynamic RIP
routing
Select the routing function to enter the routing
configuration page, select <open> open routing
function.
Note: The following parameter settings can
be set only after the dynamic RIP routing function is
