49
QoS configuration is consistent, including: traffic rate limiting, priority marking, 802.1p
priority, traffic redirection, traffic statistics.
Enter
【
Network Management
】
-
【
Trunking
】
menu bar. In Trunking page, you can enable
/ disable aggregation function, set aggregation parameters, click <Add> button to add
settings, click <Modify> button to modify settings, click <Delete > Button to delete the
setting. After setting, click the button on the bottom of the page to save the configuration.
As shown below:
The interface items are as follows:
Interface item
description
Trunk Configuration Select to enable / disable port aggregation.
Note: The following parameter settings can be set only when the
port aggregation function is enabled.
Aggregation
load
balancing mode
Select load balancing mode, you can choose MAC source /
destination address, MAC source address and MAC destination
address.
Trunk Name
Set the name of an aggregation group, up to 6 trunk groups. Enter 4
characters for the name of the trunk.
Aggregation mode
Select the aggregation mode, you can choose manual aggregation,
static LACP aggregation, dynamic LACP aggregation.
