16
17
System Check (Config.) screen
MM-DD-YYYY
DD-MM-YYYY
YYYY-MM-DD
MM/DD/YYYY
DD/MM/YYYY
YYYY/MM/DD
To change the time format, highlight the box beside
Time Format
and press the
button. The DVR toggles between 12 Hours (AM/PM) and 24 Hours
(military time).
You can save your changes by highlighting
OK
and pressing the
button. Selecting
Cancel
exits the screen without saving the changes.
System Check Screen
Highlight
System Check
in the Main menu and press the
button. The
System Check
setup screen appears.
Highlight the box under the
On/Off
heading and press the
button. This toggles between
On
and
Off
. When it is
On
, the DVR reports a fault condition if
it does not detect any recording or if there is an alarm during the designated time.
Highlight the box under the
Interval
heading and press the
button. A slide bar appears allowing you to set the check interval from 1 Hour to 30 Days.
The
Status
field displays
Good
when the DVR continues operating according to the user’s settings without any problems, there was recording, or any alarm
occurred during the designated time. The
Status
field displays
Bad
when there was no recording, or no alarm occurred during the designated time.
NOTE: When the time difference between the DVR and the time server is more than one minute, the DVR might not synchronize the time to prevent
any unexpected loss of recorded video data. If you want to synchronize the time manually, select
Now...
.
Highlight the
Run as Server
box and press the
button. Pressing the
button toggles between
On
and
Off
. When it is
On
, the DVR you are
setting up will run as a time server.
You can save your changes by highlighting
OK
and pressing the
button. Selecting
Cancel
exits the screen without saving the changes.
Highlight the box beside
Date Format
and press the
button. A list of date formats appears.
Highlight the format you wish to use and press the
button. The choices are: