Endress+Hauser PROline promag 23, Operating Instructions Manual

Page: 45 / 108

PROline Promag 23 5 Operation
Hauser 45
5.2.3 Disabling the programming mode
Programming mode is disabled if you do not press a key within 60 seconds following
automatic return to the HOME position.
You can also disable programming in the “ACCESS CODE” function by entering any
number (other than the customer's code).
5.3 Error messages
Type of error
Errors which occur during commissioning or measuring operation are displayed imme-
diately. If two or more system or process errors occur, the error with the highest priority
is the one shown on the display.
!
The measuring system distinguishes between two types of error:
System errors: This group comprises all device errors, e.g. communication errors,
hardware errors, etc. see Page 62.
Process errors: This group comprises all application errors, e.g. empty pipe,
etc. see Page 66.
Fig. 32: Error messages on the display (example)
1 Error type: P = process error, S = system error
2 Error-message type:
$
= fault message; ! = notice message (definition: see Page 46)
3 Error designation: e.g. EMPTY PIPE = measuring tube is only partly filled or completely empty
4 Error number: e.g. #401
5 Duration of most recent error occurrence (in hours, minutes and seconds)
1
2 4 5 3
+24.502
X X X X X X X X X X
# 4 0 1 0 0 : 0 0 : 0 5
P
+24.502
F06-23xxxxx
x-07-xx-x
x
-xx-
0
0
0