Endress+Hauser HART Proline Promass 83, Operating Instructions Manual

Page: 142 / 148

Technical data Proline Promass 83
142 Hauser
• The measuring device can also be operated with certified devices of other manufacturers
(interoperability).
Sanitary compatibility • 3A authorization (all measuring systems, except Promass H, O and X)
• EHEDG-tested (all measuring systems, except Promass E, H, O and X)
Pressure measuring device
approval The measuring devices can be ordered with or without PED (Pressure Equipment Directive).
If a device with PED is required, this must be ordered explicitly. For devices with nominal
diameters less than or equal to DN 25 (1"), this is neither possible nor necessary.
• With the identification PED/G1/III on the sensor nameplate, Hauser confirms
conformity with the "Basic safety requirements" of Appendix I of the Pressure Equipment
Directive 97/23/EC.
• Devices with this identification (with PED) are suitable for the following types of fluid:
– Fluids of Group 1 and 2 with a steam pressure of greater or smaller and equal than 0.5
bar (7.3 psi)
– Unstable gases
• Devices without this identification (without PED) are designed and manufactured
according to good engineering practice. They correspond to the requirements of Art. 3,
Section 3 of the Pressure Equipment Directive 97/23/EC. Their application is illustrated in
Diagrams 6 to 9 in Appendix II of the Pressure Equipment Directive 97/23/EC.
Functional safety SIL -2: In accordance with IEC 61508/IEC 61511-1 (FDIS)
Other standards and
guidelines • EN 60529
Degrees of protection by housing (IP code).
• EN 61010-1
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures.
• IEC/EN 61326
"Emission in accordance with requirements for Class A".
Electromagnetic compatibility (EMC-requirements).
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control
equipment.
• NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters
with analog output signal.
• NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics.
10.13 Ordering information
The Hauser service organization can provide detailed ordering information and
information on the order codes on request.
10.14 Accessories
Various accessories, which can be ordered separately from Hauser, are available for
the transmitter and the sensor
→
85.