Biometra TAdvanced
Safety instructions
Version 02_20
13
The ventilation fittings at the rear of the device must be unobstructed and
operational. Covered ventilation grilles or slits etc. may cause the device to break
down or may cause damage to it.
The use of oil between the samples and the sample block is not necessary to
achieve an improved heat exchange. However, if you still want to use oil, you
should use mineral oil. Do not use silicone oil.
Be careful to avoid crushing or pinching injuries when closing the device.
The Biometra TAdvanced may cause burns. The following has to be observed:
The thermal block, the samples and the heated lid reach high temperatures. There
is a risk of burns during contact.
Ensure that the lid is securely closed before starting the program! Do not touch the
heated lid!
The rapid heating of the thermal block can cause liquids to boil explosively. Always
wear safety goggles during operation!
Do not touch hot sample tubes or plates and do not open them or boiling liquid
may escape!
Only use plates and tubes that are suitable for high temperatures (up to 100°C), fit
well into the thermal block (no shaking) and whose lids seal tightly!
2.6.2
Safety instructions: protection against explosion and fire
The Biometra TAdvanced must not be operated in an explosive environment.
The Biometra TAdvanced must not be operated with flammable, explosive or volatile
substances.
2.6.3
Safety instructions: electrical equipment
Work on the electrical components of the Biometra TAdvanced may only be performed
by a qualified electrical technician in accordance with the applicable electrical
engineering rules. Life-threatening electrical voltages may occur in the interior of the
Biometra TAdvanced!
The following has to be observed:
Any work on the interior of the device may only be carried out by the customer
service of Biometra GmbH and specially authorized technicians.
The electrical components must be checked regularly by a qualified electrician. Any
defects, such as loose connections, faulty or damaged cables, must be repaired
without delay.
Before opening the device it must be switched off at the power switch and the
mains plug must be disconnected from the mains outlet!
The Biometra TAdvanced must be switched off immediately using the power switch
(on the equipment back plate) and the mains plug disconnected from the power
supply if any faults occur in the electric components.