Endorphin.es ANDREW HUANG GHOST 16hp, Manual, Page: 8 / 19

present at the CLOCK IN jack, the knob acts as a divider / multiplier for this
clock with the divisors written around the knob on the panel.
15.
TIME CV INPUT JACK:
­5…+5V external CV control for the speed of
the delay’s repetitions, follows 1v/oct tracking. Is inversely summed with the
TIME/DIV knob value when no external CLOCK IN applied: higher CV values
shorten the delay time and lower values increase the delay time. When the
delay is synchronized to external
CLOCK IN , that CV sets the clock divider
also summed with the value of TIME/DIV knob.
16.
ROUTING /* BUTTON:
routing chain switching as well as
multifunction shift button. Short presses will cycle through three different
orders of audio effects (see FX CHAIN STRUCTURE). Acts as a ‘shift’ button
when held down while using other controls (shift functions are labeled with
/*
on the panel).
17.
TAP
/TAPS*
BUTTON:
acts as a tap tempo button for the delay speed.
When internal clock is enabled (no patch cable connected) this button blinks
fully lit, shown by the symbol under it: . When external clock is patched, the
button blinks semi­lit shown by the symbol under it: . Secondary function
( R TAPS ) changes the stereo behavior of the taps produced by
the delay. Available delay tap configurations are:
LRLR: left and right summed, taps 1 and 3 hard panned left, taps 2 and 4
hard panned right.
LRRL: left and right summed, taps 1 and 4 hard panned left, taps 2 and 3
hard panned right.
STEREO: left and right inputs tap independently in their corresponding left
and right outputs. In this mode the total delay time is halved.
18.
CLOCK IN JACK:
0…+5V external input for the clock that sets the
TEMPO of the delay. External clock sets the delay time in sixteenth notes.
Module switches to external clock automatically when a patch cable is
inserted in the
CLOCK IN jack: TAP button blinks semi­lit following the
incoming clock.
19.
REVERB DRY/WET CV JACK:
0…+5V external CV control over
the DRY/WET MIX OF THE REVERB . Normalled to +5V when no patch cable
is inserted.
20.
REVERB KNOB:
manual control of the REVERB DRY/WET mix level,
acts as attenuator for DRY/WET CV jack.
21.
TAIL
/PREDELAY*
KNOB:
primary function controls the decay of the
REVERB’s TAIL , Secondary function in combination with ROUTING /* button
controls the AMOUNT OF PRE­DELAY for the reverb. Is summed with an
external CV applied to the TAIL CV input jack.