Endorphin.es ANDREW HUANG GHOST 16hp, Manual, Page: 17 / 19


Set DISTORTION to 20% and COMPRESSOR to 70% to bring in some noise

Send a PITCH sequence to the VCF CV input. COMB does not track 1v/oct, but this
allows you to highlight frequencies without doubling the amplitude of the fundamental of
the sound source. Set the
FREQUENCY CUTOFF knob to 11:00 with VCF CV attenuverter
fully CW

Start the sequencer and listen how GHOST creates timbres on top of a steady oscillator

Patch another 1v/oct PITCH CV signal to your oscillator and play around with the notes,
you will hear how new ghost harmonies appear, let them direct your next note.
FIRMWARE UPDATE
Firmware updates are essential for any digital modules. They bring new features or
bug fixes. Feel free to write any bugs, features ideas or improvements to
beta@endorphin.es
To update the firmware on your Ghost, first download the latest firmware file once
available on ENDORPHIN.ES website: https://www.endorphin.es/modules/p/ghost
The update procedure is done via audio: either computer or phone will work, we
advise you to disable all notifications (flight mode) so that the update is not
interrupted.
1. Power OFF your modular system.
2. Unplug all the cables from GHOST except a simple mono or stereo cable
connecting the audio output from your computer headphones output to the
AUDIO IN 1 input of the module.
3. Set the output volume of your computer to 100% or slightly lower.
4. Hold ROUTING while powering your system ON ­ you will see both CLIP and
/ ENV DEPTH* LEDs on.
5. Open the Ghost_Update_xxx.wav file with any audio player. Press play and
wait 1.5+ minutes while the firmware is updating. Both CLIP and / ENV
DEPTH* LEDs will slowly blink during that procedure and a row of 4 buttons
will show the approximate signal level as imaginary VU meter. Try to adjust
the volume of the update so it will not clip but also will be enough level to
blink the VU meter.
6. If all 4 buttons LEDs blink fast during update or both CLIP and /ENV
DEPTH* LEDs stop blinking, that means an error occurred in the update and
you have to stop the audio file playback, reset the firmware listening input
(single
ROUTING button press), adjust the audio file playback volume and
then start it again.