Endorphin.es ANDREW HUANG GHOST 16hp, Manual, Page: 5 / 19

CONNECTING THE POWER
Before installing a new module in your case, ensure your power supply has a free
power header and sufficient available capacity to power the module.
Connect the module directly to the power bus­board with supplied 10­16 ribbon
cable like any other eurorack module. Pair of
RED / BROWN pins on the multicolor
ribbon cable corresponds to negative ­12V .
Make sure to align the power cable with the ‘RED/BROWN STRIPE ’ label on the
module that corresponds to ­12V, to the 10­pin connector and with typically a white
line for the 16­pin connector on the bus board.
TECHNICAL SPECIFICATIONS
 Width: 16 HP/TE, depth: 25 cm / 1” with inserted ribbon cable
 Current draw: +12V: 130 mA, ­12V: 35 mA

Audio I/O: 96 kHz 16 bit with 32 bit floating point internal processing
 CV capture: 16 bit, 2 kHz
 CV range: 0…+5V typically with up to 0…+10V. ­5…+5V for 1v/oct and VCF.
 Audio input range: typical eurorack st/­5V (10Vpp) with up to 18Vpp
when saturation starts (at 21 dBu).
 Audio output: t/­5V eurorack standard