VSR-30™ Installation Guide
3
Note:
An eight-pin modular (RJ-45) to DB-9 adapter is the standard adapter to connect
the Supervisory cable to a PC. This adapter is shipped with the unit. The following
alternate adapters are also available. (Contact Encore Networks, Inc., if you need either
of these adapters.)
• An RJ-45 to DB-25 adapter for connection to most asynchronous terminals
• An RJ-45 to DB-25 modem adapter to connect a modem, for out-of-band management
or remote configuration
B Wireless Support
If you ordered a CDMA or GSM wireless card with the VSR-30, you need to set up the card
for use in the carrier network. And, if you wish to change the default settings for wireless
access, you need to reconfigure the wireless port.
In addition, a GSM wireless card must hold the appropriate Subscriber Identity Module
(SIM) for access to the carrier’s GSM wireless network.
To configure the device for wireless use, see the BANDIT Products Wireless Access Guide.
C Logging In
1
On the PC, open a terminal-emulation session, such as HyperTerminal. Use the settings
in
Table 1
to establish communication between the terminal console and the VSR.
2
On the terminal console, press Enter to connect to the attached device.
❖
After successful log-in, the Main Menu appears.
Table 1. Supervisory Port Communication Settings
Parameter
Value
Bits per second
9600
Data bits
8
Parity
None
Stop bit
1
Flow control
Hardware