VSR-30™ Installation Guide
25
d
Configure IP addresses for the SNMP Trap Table.
5
Now you can configure an SNMP manager on your control terminal. (Encore Networks
does not furnish SNMP manager software.)
F Saving (Writing) the Device’s Configuration
Note:
If you do not save the configuration before you reset or exit the VSR (or before the
connection times out), the configuration will be lost.
After the unit has been configured, save (write) the configuration. Do the following:
1
On the Main Menu, select Write Configuration.
2
Select Yes.
❖
The device will notify you when it has saved the configuration.
Note:
If the device’s software detects an error in the configuration, it will not save it.
Review the configuration. After you have revised the configuration to your
satisfaction, save it.
3
Press Enter.
G Restarting (Resetting) the Device
To use the saved configuration, you must reset the VSR. Do the following:
Note:
If you want to use your new configuration, you must save (write) the configuration
before resetting the unit. Otherwise, the new configuration will be lost.
1
On the Main Menu, select Reset Unit.
2
Select Yes.
Note:
If you have not yet saved the new configuration, the system asks whether to
save it. Answer yes or no.
❖
The device resets.
3
Regardless of screen instructions, do not type anything until you see the banner:
BANDIT, ENCORE NETWORKS INC
. Then press Enter.
❖
The Main Menu is displayed.
