2 • FSD Installation and Operation Manual
026-1400 Rev 3 22-MAR-2011
2
Installation
This section of the manual covers wiring and
mounting for the FSD.
2.1. Wiring
1. Step 1: Using the four screws on the front of
the mounting plate, unscrew the cover of the
FSD and remove, exposing the back of the
enclosure. Once the top has been separated
from the back of the enclosure, unplug the 8-
pin connector and RS232 cable (
Step 1
of
Figure 2-1
) from the circuit board (
P/N 537-
1100
).
2. Step 2: Mount the base enclosure and refer to
Section 2.3.,
Mounting
for instructions.
3. Step 3: Once the unit has been mounted,
depending on the voltage input, wire either
120VAC, 208VAC, or 240VAC Hot leg to
the corresponding terminal block label. Then
wire the Neutral or L2 leg to the terminal
block labeled Neutral. Wire Ground to
Ground as indicated by
Step 3
of
Figure 2-1
.
4. Step 4: Open the ferrite (
P/N 090-0008
) and
run the Ethernet cable through, wrapping the
cable around the ferrite twice (two turns),
near the Ethernet port (LAN) on the back of
the display, and close the ferrite (
Figure 2-2
)
around the Ethernet cable.
5. Step 5: Plug the Ethernet cable into the RJ45
connector (LAN) on the back of the FSD’s
display module (
P/N 750-5100
) as indicated
by
Step 5
of
Figure 2-3
.
6. Step 6: Reconnect the 8-pin connector and
RS232 cable to the circuit board in
Step 6
of
Figure 2-3
.
7. Step 7: Replace the mounting plate back onto
the enclosure and attach using the four
screws.
NOTE: Provide either 120VAC, 208VAC, or
240VAC (40VA max) to the FSD terminal
block through a store circuit breaker. The
breaker size should be 20 amps or less.
Figure 2-1
- 8-Pin Connector and RS232 Cable Connections
Figure 2-2
- Ferrite Installation on Ethernet Cable
Inside Back of Enclosure
9.0”
STEP 3
8.0”
Transformer
G
ro
un
d
1
20
V
A
C
N
e
u
tra
l
2
08
V
A
C
2
40
V
A
C
Hot in
FSD Circuit
Board
RS2
32
AUX
+
+ _
+ _
_
Ea
rth
Gro
und
Ala
rm
LE
D
Hor
nV
de
Ou
t
Dis
pla
y
STEP 1
