EES-101 Series Ultrasonic Flowmeter
Revision: 3.0.1
Page 25 of 65
Transducer Mounting
Four mounting methods are available:
0.
V
1.
Z
2.
N
Transducer Spacing
The operator must mount the transducer according to
the transducer spacing displayed (be sure that the
transducer spacing must be measured precisely during
installation). The system will display the data
automatically after the pipe parameter had been
entered.
Initial Parameter Setups and Save
Load and save the parameters. 4 different sets of setup
conditions/groups are available to load and save by
three methods
0.
Entry to Save
1.
Entry to Load
2.
To Browse
Select "Entry to Save", press
. An ID code and the
original parameters are displayed in the window. Press
UP or DOWN ARROW to move the ID code, then
press the
key again to save the current
parameter in the current ID room. When selecting
"Entry to Load", press ENT, and the system will read
and calculate the parameters automatically and display
the transducer mounting spacing in Window M25.
Related parameters include the setting parameters of
M11 - M24.
Cross-sectional Area
Holding with Poor Sig
Select "Yes" to hold last good flow signal displayed if
the Flowmeter experiences a poor signal condition.
This function will allow to calculate flow totalizer
data without interruption. Select "NO", instead.
Menu
2
4
Transducer Mounting
0. V
Menu
2
5
Transducer Spacing
159.86 mm
Menu
2
6
Enter
Enter
Parameter Setups [26
0.Entry to SAVE
Menu
2
7
Cross-sectional Area
31415.9 mm2
Menu
2
8
Holding with PoorSig
NO