EMC-PARTNER IMU4000, User Manual, Page: 38 / 104

IMU4000
38/104
fig. 4.1.1
4.1.1.1 The touch screen monitor (1)
All important information for the operator is permanently shown on the monitor during EMC testing. The
large graphic display includes hints or setting range information.
4.1.1.2 Selection of the possible EMC tests (2)
The program in the IMU4000 is very complex, therefore each emc tests has his own selection logo. When
the Hardware is inserted automatically the EMC logo is activated (green background).
4.1.1.3 The USB Port (4)
Via this interface, service data can be stored on a USB stick. In case of failure the data can be sent via
Email to EMC PARTNER for analysis.
4.1.1.4 Button Run (5)
With the „Run“ button, a test can be started.
4.1.1.5 Push button ON/STBY (6)
With this button, the IMU4000 will be set into the power ON / OFF mode. In the turn off mode, the control
and the signals are deactivated. In Standby IMU4000, power consumption is at a minimum of 5 W.
4.1.1.6 Rotary knob for selecting test parameter and Enter (7)
If the cursor is activated in one line of the display, then data can be input with the rotary knob. Each data
input must be terminated with ENTER by pressing the rotary knob.
4.1.1.7 Button STOP (8)
With the „STOP“ button, a test can be stopped or interrupted.
4.1.1.8 Measuring outputs EUT Power Voltage (9) and Current (10)
A signal corresponding to the mains voltage is available at these two BNC outputs „EUT power“. Maximum
12 V for the voltage at the output (9) and maximum 12 V for the current at the output (10).
2
6
7
4
5
1
13
12 11
10 9
8