EMBRON Hatteland HD 12T21 MMC Series, User Manual, Page: 32 / 124

32
Installation Procedures
Installation
IND100078-34
Installation Procedure - TMB Versions
Procedure suitable for: Display (MMD/STD) and Panel Computer (MMC) Series X Generation (G1) product ranges.
19 inch model used as example in this procedure.
You need:
- M4 Unbrako® Hex Key tool (not included with delivery).
- M7 Unbrako® Hex Key tool (not included with delivery) - Needed only for alternative procedure in Step 2,3.
- M17 Open End Wrench tool (not included with delivery) - Needed only for alternative procedure in Step 2,3.
- Fasteners (6 pcs M6) for mounting complete unit onto table or desktop location (not included with delivery).
- 1 pcs of HD TMB SX1-A1 Mounting Bracket Kit (for 12 and 15 inch)
- or 1 pcs of HD TMB SX1-B1 Mounting Bracket Kit (for 17 and 19 inch)
Boxed marked with GREY color below are considered alternative procedures. In most cases, these procedures can
be ignored as suggested by factory.
Attention: A suitable pre-drilled location and knowledge of measurements for both main unit and
brackets/tilting functionality should be prepared and checked prior to mounting. Please disconnect
ALL cables before proceeding. Please review User Manual or visit www.hattelandtechnology.com
for Technical Drawings regarding measurements for both main unit and Mounting Brackets.
▼ 1: Place the unit on a dry, flat, clean, soft surface (i.e. table)
with the glass front facing down as illustrated. Connector area
should be facing downwards from you.
▼ 2: By factory default the lower part of the bracket (Feet
Base) are tightly fastened by the center Hex Socket Bolt and
Locking Nut. Tilting can not be performed by hand. If you
need to pre-configure the tilt angle of the final assembled
unit with brackets BEFORE you secure it into the installation
location, simply unscrew and loosen the Locking Nut (M17)
first and the Hex Socket Screw (M7) as indicated below. If
there is no need to adjust the Feet Base (use recommended
factory default position of 0 degree), skip to step 4 now.
Seen from
above
Connector Area
1
2
▼ 3: Once loosened a bit, pull out the Tilting Lock Pin, rotate it 90° (FIG1 / FIG2) and you are now able to tilt/rotate the Feet
Base by hand (FIG3). Once the desired angle has been reached, rotate the Tilting Lock Pin 90° and lock the angle into the
nearest “click” the Locking Pin matches (FIG 1 / FIG2). Make sure both Feet Base are tilted/rotated to EXACTLY the same
angle! Secure both Hex Socket Bolts and Locking Bolt (FIG4) so they cannot move by themselves when proceeding to next
step. Use Torque Force 25Nm.
FIG1
FIG2
Locked Unlocked
FIG3
FIG4