DATAPLOT GmbH
Gutenbergstraße 15
24558 Henstedt-Ulzburg
Germany
Telephone: +49 4193 995-0 Fax: +49 4193 995-220
www.dataplot.de
Page 16 / 28
4.
Lay a punched banner section in the centre of the die.
For multi-layer punching lay several accordingly over
each other. Then adjust the laser point so that it points
to the centre of the punched section.
5.
To adjust towards the front and rear rotate the bracket
in the horizontal plane.
6.
To adjust towards the left and right rotate the pointer.
The Phillips-head screw is the fulcrum and under the
wing screw is an elongated hole for adjusting the
position.
7.
Actuate the manual operating lever downwards to check
that the upper die cannot collide with the LED pointer.
8.
Connect the power supply to the pointer or glue the
battery compartment to a suitable spot und connect.