from damaging the lawn if the ground is uneven.
The higher position excludes this possibility.
To change the position:
with the round profile cutting deck (
☛
2.2),
unscrew and remove the pin (1) then reposi-
tion the wheel (2) in the upper and lower hole
of the wale corresponding to the wheel diame-
ter;
with the square profile cutting deck
(
☛
2.2),
release the spring (3) with a screwdri-
ver to remove the pin and reposition the wheel
(4) as desired.
This work is to be done to all four wheels, WITH THE
ENGINE OFF AND THE BLADES DISENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– engage the blades (
☛
4.9);
– start moving forwards onto the grass area very gradually and with particular
caution, as already described;
– adjust the forward speed and the cutting height (
☛
4.10) according to the lawn
condition (height, density and dampness of the grass). On flat ground, these
general conditions can be followed
High and dense grass - wet lawn
2,5 km/h
Average condition grass
4 ... 6 km/h
Low grass - dry lawn
over 6 km/h
For hydrostatic drive models:
The speed is controlled in a gradual and progressive way by the pressure on
the drive pedal.
When cutting on sloping ground, the forward speed
!
WARNING!
➤
!
WARNING!
➤
➤
EN 28
HOW TO USE THE MACHINE
3
4
1
2
Ø 80
Ø 100
