Elumen8 KUDOS CYCLONE, User Manual

Page: 13 / 37

12
3. Universal DMX controller
You do not need to turn the unit off when you change the DMX address, the new DMX address
setting will take effect immediately. Every time you power the unit on, it will move all the motors
to their ‘home’ position and you may hear some movement noises for about 20 seconds. After
that the unit will be ready to receive a DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is good when you want an
instant show. You have to set the first unit in master mode Show Mode and select show 1 , show 2,
show 3 or show 4 mode. When the DMX input socket has nothing plugged into it, its master LED
will be constantly on and sound LED will flash to the music. The other units will have to be set in
slave mode and select Slave 1 (normal) or Slave 2 (2 light show) mode, the units will be linked by
DMX cables plugged into the DMX sockets (daisy chain) and the slave LEDs will be constantly on.
2-­‐light show
In slave mode , Slave 1 means the unit works normally and Slave 2 means 2-­‐light show. In order to
create a great light show, you can set Slave 2 on the second unit to get contrast movement to
each other, even if you have only two units.
4.2 Easy Controller
The CA-­‐8 easy remote control is used only in master/slave mode. By connecting
to the 1/4” jack socket of the first unit, you will find that the remote controller on
the first unit will control all the other units in Stand by, and Mode selection.
Stand By Blackout the unit
Function
1. Sync. Strobe
2. Two-­‐light
strobe
3. Sound Strobe
Select show
1-­‐4
1. Hold to change Master Pan position
2. Hold to change Master Tilt position
3. Hold to change Master Dimmer
4. Hold to change Slave Pan position
5. Hold to change Slave Tilt position
6. Hold to change Slave Dimmer