________________________________________________________________________________
_________________________________________________________________________________
Universal Network Terminal TAU-72.IP/TAU-36.IP 99
24 (0x18)
class 3
26 (0x1A)
assured forwarding, low drop precedence (Class3, AF31);
28 (0x1C)
assured forwarding, low drop precedence (Class3, AF32);
30 (0x1E)
assured forwarding, low drop precedence (Class3, AF33);
32 (0x20)
class 4
34 (0x22)
assured forwarding, low drop precedence (Class4, AF41);
36 (0x24)
assured forwarding, low drop precedence (Class4, AF42);
38 (0x26)
assured forwarding, low drop precedence (Class4, AF43);
40 (0x28)
class 5
46 (0x2E)
expedited forwarding, low drop precedence (Class5, Expedited Forwarding);
IP Precedence:
0 (0x00)
IPP0 (Routine)
8 (0x08)
IPP1 (Priority)
16 (0x10)
IPP2 (Immediate)
24 (0x18)
IPP3 (Flash)
32 (0x20)
IPP4 (Flash Override)
40 (0x28)
IPP5 (Critical)
48 (0x30)
IPP6 (Internetwork Control)
56 (0x38)
IPP7 (Network Control)
To discard all changes made to configuration, click the
Undo All Changes button.
To set default parameters,
click the
Defaults
button (the figure below shows default values). To apply changes, click the
Submit Changes
button.
5.1.2.4
The
‘
Ports Configuration of Subscriber Ports
’
submenu (Ports)
In the
'Ports'
submenu, you may configure subscriber ports of the device.
You may use up to 8 subscriber profiles to configure the following port settings:
CallerID mode,
Flash impulse duration, signal levels strengthening/weakening, priority between CFB and CW
services, 'Music on hold' service, payphone mode.
In
'Subscriber profile'
item of the
'Custom' tab,
you may assign one of the configured subscriber profiles to each port.
Profile 1 is assigned for all
ports by default. To open the subscriber profile configuration window, click
'Subscriber profiles'
in
'PBX/Ports' tab.
If you have to configure a custom value for any of the parameters listed above, you
have to configure it in
'PBX/Ports'
menu by clicking 'Edit
/Common' button. To use custom
settings, it is absolutely necessary to select 'Custom' checkbox (in
'PBX/Ports'
tab
–
'Edit
/Custom' or
'PBX/Ports'
) in the port configuration!
You don't have to reboot the gateway in order to apply port settings. Changing
'SIP port'
parameter
will lead to termination of current calls. Changing other parameters will not disrupt any of the
established connections!