SPECIFICATIONS
Power supply:
220-240V~, 50Hz
Power consumption: 16 Watts
Blades diameter:
15 cm
Protection class:
II
Before delivery our devices are subject to rigorous quality control. If, despite all care, damage has
occurred during production or transportation, please return the device to your dealer. In addition to
statutory legal rights, the purchaser has an option to claim under the terms of the following warranty:
For the purchased device we provide 2 years warranty, commencing from the day of purchase. During
this period we will remedy all defects free of charge, which can be demonstrably attributed to material
or manufacturing defects, by repair or exchange. Defects which arise due to improper handling of the
device and malfunctions due to interventions and repairs by third parties or the fitting of non-original
parts, are not covered by this warranty.
SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
9016N6/1208
INSTRUCTIONS ON ENVIRONMENT PROTECTION
elta GmbH
Carl-Zeiss-Str. 8
63322 Rödermark
The device is marked with the CE symbol and thus
complies with the relevant European directives.
Do not dispose of this product in the usual household garbage at the end of its life cycle;
hand it over ata collection point for the recycling of electrical and electronic appliances.
The symbol on the product, the Instructions for use or the packing will inform about the
methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or other
forms of re-utilization of old appliances, you are making an important contribution to protect our
environment.
Please inquire at the community administration for the authorized disposal location.
GB
GB
9
10
GB
GB
WARRANTY AND CUSTOMER SERVICE
OPENING THE PROTECTIVE GRID AND CLEANING THE BLADES
Remove the protective grid before cleaning the blades. Please follow these steps:
• Turn the desk fan off. Disconnect from mains power supply to avoid accidental operation or touching
live components.
• Open the three clips of the protective grid by carefully squeezing the front grid and holding the fan
with the other hand.
• First open the two clips at the bottom left and right, afterwards the top clip.
• The blades cannot be removed; you can easily reach the rear of the blades for cleaning purposes.
• Clean the three blades and the motor casing with a damp cloth. In case of stubborn dirt on the blades
use some household detergent. Do not use any abrasives or sharp cleaning utensils, this will damage
the finish and the blades.
• Dry all components properly.
• Place the front protective grid on top of the rear protective grid. At the top you will see a tab next to
the clip fitting into the hole in the rear protective grid.
• Align front and rear protective grids and squeeze until the clips snap in place.
• Your desk fan is again ready for use. Before use please check again that the assembly followed the
manual in all steps.
