Elster TC210, Operating Manual And Installation Instructions

Page: 41 / 79

TemperatureVolume Corrector TC210
ELSTER HANDEL GmbH 41
3.3.3 Service
AD Address Designation / value Unit Access DC
CLR 4:130 Clear status register - S 2
- 1:1F7 Display test - - 1
CP.I1 1:253 cp value Input 1 1/m³ C 7
CP.I2 2:253 cp value Input 2 1/m³ S 7
CP.O1 1:611 cp value Output 1 1/m³ C* 8
CP.O2 2:611 cp value Output 2 1/m³ S* 8
SAVE 1:131 Save all data - S 2
BAT.C 1:1F3 Battery capacity Ah S 8
ST.SL 3:170 Status of supplier's lock: Status / close - S 7
Cod.S 3:171 Supplier's combination, enter / change - S 11
CLR.V 2:130 Clear counters - C 2
FRZ 1:1FE Freeze - S 2
CLR.X 1:130 Initialise device - C 2
Md.O1 1:605 Mode for Output 1 - C* 8
SC.O1 1:606 Source Output 1 - C* 8
SP.O1 1:607 Status pointer, Output 1 - C* 8
STAT 1:100 Momentary overall status - - 5
*
= The displayed value can only be changed via the interface.
(For legend see page 28)
The four values marked in grey are user-specific, i.e. the user can himself set which values
are displayed in this list. The factory settings are the above values. The values which can
be set at this point can be taken from the data list (Appendix C:).
The setting of the values to be displayed occurs by entering the addresses of the values to
be displayed with the parameterisation software "WinPADS" under the addresses "9:1C2"
to "12:1C2".
CLR Clear status register
With this function all the status register content (alarms and warnings) can be
cleared (see Chapter 2.4.5 for procedure). If the alarm or warning states are still
present, they are again directly entered as messages.
- Display test
The display flashes to test all segments.
CP.I1 cp value Input 1
Pulse constant (parameter of the connected gas meter) for conversion of the
pulses counted on Input 1 into the volume counter
V (
→
3.1); the increase in vol-
ume is directly accepted into the total actual volume VT (
→
3.1). (See Chapter
2.4.3 for the principal procedure for the change on the device.)
CP.I1 indicates how many pulses correspond to the volume of 1 m
3
.