14
ETS Database Parameters
KNX B4 Universal Interface
• Version: 13.09.2021 • from application 1.0 • Technical changes and errors excepted.
6.2.2. Scene
If the saving function is enabled, a long button press can be used to store an 8-bit
scene. For 8-bit scenes there are 64 scene numbers available and for 1-bit scenes there
are 2 scene numbers available.
The here defined value will be sent to the object on a rising edge; available for "switch
on rising edge".
Value falling edge
off • on
The here defined value will be sent to the object on a falling edge; available for "switch
on rising edge" and "send status".
Send cyclic
• disabled
• if value = 1
• if value = 0
• toggle
If enabled, the parameterized object value will be sent cyclically; available for "send sta-
tus".
Cyclic sending [s]
1…3000; 10
Time interval for "Send cyclic".
Value short press
• nothing
• off
• on
• if contact is opened or closed
The here defined action is executed after a short button press; available for "switch on
short/long button press".
Value long press
• nothing
• off
• on
• if contact is opened or closed
The here defined action is executed after a long button press; available for "switch on
short/long button press".
Long button press after
0.3...30.0 s; 2.0 s
Duration that the input needs to be logical high to start the long operation.
If the input is logical high for a shorter time, only the command for short operation will
be sent; available for "Switch short/long".
Interlock
disabled • enabled
If Interlock is active, changes at the Input are not considered until the Interlock is deacti-
vated again.
Scene
• without saving function
• saving function
• 1-bit
Sets the saving option for an 8-bit scene or sets 1-bit scenes.
Contact type
normally open • normally closed
Defines the contact type at the input, NO or NC. If NO is selected, the input is logic high
after the contact is closed.
