Elsist MISSION 1000, Instruction Manual

Page: 21 / 26

MISSION 1K●2K●3K
SINGLE PHASE
Rev. 02
– 19 March 2015
21
6.1 LED indication and warning table
Appendix 1: Fault codes
FAULT CODE FAULT CAUSATION
00
－
19
Bus Fault
20
－
39
Inverter Fault
40
－
44 Over Heat
45
－
49 Output short circuit
50
－
54 Overload
55
－
59 Output Relay Fault
60
－
64 Input NTC Fault
65
－
69 Auxiliary Power Fault
70
－
74
Input Fuse Fault
99 Others
Appendix 2: The corresponding working status of indications
NO WORKING STATUS
INDICATION
WARNING REMARKS
NOR BAT BPS FAULT
1 Line mode
Normal voltage
●
None
High/low voltage protection,
turn to battery mode
● ● ★
Once every four
seconds
2 Battery mode
Normal voltage
● ● ★
Once every four
seconds
Battery Voltage abnormal
warning
● ★ ★
Once per second
3 Bypass mode
Main AC Normal voltage in
bypass mode
●
★
Once every two
minutes Eliminate after starting the
UPS
Main AC high voltage warning
in bypass mode
★
Once every four
seconds
Main AC low voltage warning
in bypass mode
★
Once every four
seconds
4 Battery disconnect warning
Bypass mode
● ★
Once every four
seconds Affirm if the battery switch is
closed
Inverting mode
●
★
Once every four
seconds Affirm if the battery switch is
closed
Power up or start Six times
Affirm if the battery is
connected well
5 Output overload protection
Overload warning in line
mode,
● ★
Twice per
seconds Remove the less important
loads
Overload in line mode,
protection
● ●
Long beeps
Remove the less important
loads
Overload warning in battery
mode
● ●
★
Twice per
second Remove the less important
loads
Overload in battery mode,
protection
● ● ●
Long beeps
Remove the less important
loads
6
Overload warning in bypass
● ★
Once every 2 Remove the less important