Controller Data Sheets
33
IntelliTouch PC-Bus Controller (E281{A}-4025)
Verify the controller’s switch settings are as follows:
(From Bottom)
12-Bit Mode
SW1 - ON
Reserved
SW2 - ON
Stream Mode
SW3 - OFF
Reserved
SW4 - ON
Z-axis enable
SW5 - ON
Reserved
SW6 - ON
Reserved
SW7 - ON
Reserved
SW8 - ON
Next, set the controller’s Base I/O Port address with the W2 and W3 jumpers. W3
selects the high-order address, and W2 the low-order address. The values of the
settings are shown in the following table:
W3
W2
Position
Value
Position
Value
(from top)
(in hex)
(from top)
(in hex)
4
300
8
E0
3 (recommended)
200
7
C0
2
100
6
A0
1
000
5 (recommended)
80
4
60
3
40
2
20
1
00
To calculate the Base I/O Port address, add the values of the jumpered positions of
W3 and W2. For example, the E281{A}-4025 is usually shipped jumpered for a
Base I/O Port address of 280 hexadecimal. W3 is jumpered in the third position
(200), and W2 is jumpered in the fifth position (80). The address is the sum of
200 + 80, which is 280.