10
Chapter 2 - Installing MonitorMouse for OS/2
Serial Touchscreen Controller on PC-Bus System
Change your CONFIG.SYS file as follows:
TGO &'8+%'%>15>/175'5;5 =HNCIU?
FGXKEGE>GNQ>OQPOQWU[U EQPVTQNNGT %1/ RQTV DCWF TCVG
FGXKEGE>QU>OQWUGU[U UV[RGGNQOQW =HNCIU MGGR UCOG CU CDQXG?
where <controller> is:
2300 for the IntelliTouch E281-2300 serial controller.
4002 for the IntelliTouch E281{A}-4002 serial controller.
2210 for the AccuTouch E271-2210 serial controller.
140
for the AccuTouch E271-140 serial controller.
<COM port> is the number of the COM port where the serial output of the
touchscreen controller is connected.
<baud rate> matches the switch or jumper settings on the controller.
Here is an example MonitorMouse for OS/2 DEVICE command:
FGXKEGE>GNQ>OQPOQWU[U
No Mouse
If you do not wish to have a mouse connected, change the "stype=elomou$" flag to
"type=elomou$" on the DEVICE=MOUSE.SYS command.
Disabling the COM Drivers
If your system COM ports are being used by the touchscreen and mouse, REM out
the DEVICE=COM.SYS and DEVICE=VCOM.SYS commands (if present) in
CONFIG.SYS. This prevents the COM drivers from displaying a message saying
the COM ports are unavailable.
If only the touchscreen is using a COM port, move the DEVICE=COM.SYS and
DEVICE=VCOM.SYS commands before the DEVICE=MONMOU01.SYS
command in CONFIG.SYS. Then add the flag (<COM Port>,0,0) to COM.SYS,
where <COM Port> is the same as on the DEVICE=MONMOU01.SYS command.
For example,
&'8+%'%>15>%1/5;5
Reboot and proceed to Step 4, page 14.