Elnec DATAMAN-40PRO, User Manual

Page: 92 / 162

If you wish display additional information about the current device, use button Device info or
an <Ctrl+F1> key. This command provides a size of device, organization, programming
algorithm and a list of programmers (including auxiliary modules) that supported this device.
You can find here package information and other general information about current device
too.
Device / Select EPROM /Flash by ID
Use this command for autoselect an EPROM or Flash as active device by reading the device
ID. The programmer can automatically identify certain devices by the reading the
manufacturer and the device-ID that are burnt into the chip. This only applies to EPROM or
Flash that supports this feature. If the device does not support a chip ID and manufacturer's
ID, a message will be displayed indicating this as an unknown or not supported device.
If more devices with identical chip ID and manufacturer's ID were detected, the list of these
devices will be displayed. A corresponding device can be chosen from this list by selecting its
number (or manufacturer name) from list and press
<Enter> (or click OK button). Press a key
<Esc> or click Cancel button at any time to cancel device selection without affecting the
currently selected device.
Warning: The control program only support this time EPROM’s and Flash with 28 and 32
pins. Any of programmers determines pins number automatically. For other programmers you
must enter this number manually.
The programmer applies a high voltage to the appropriate pins on the socket. This is
necessary to enable the system to read the device ID. Do not insert into the socket a device
that is not an EPROM or Flash. It may be damaged when the programmer applies the high
voltage.
We don't recommend apply this command to:
1) 2764 and 27128 EPROM types, because most of them ID not supports
2) Flash memories with non-standard pinout (e.g. Firmware Hub Flash)
3) Flash memories, which don't accept Vid voltage at A9 pin
4) low voltage EPROM and Flash memories
Device / Device options
All settings of this menu are used for programming process, serialization and associated file
control.
Device / Device options / Operation options
All settings of this command are used for programming process control. This is a flexible
environment, which content items associated with current device and programmer type.
Items, which are valid for the current device but aren't supported by current programmer, are
disabled. These settings are saving to disk along with associated device by
File / Exit and
save command.
The commonly used term are also explained in the user manual to programmer. The special
terms used here are exactly the terms used by manufacturer of respective chip. Please read
the documentation to the chip you want to program for explanation of all used terms.
List of commonly used items:
92