Elnec DATAMAN-40PRO, User Manual

Page: 38 / 162

Technical specification
HARDWARE
Base unit, DACs
•
USB 2.0 high-speed compatible port, up to 480 Mb/s transfer rate
•
FPGA based IEEE 1284 slave printer port, up to 1MB/s transfer rate (except
DATAMAN-48PRO2C)
•
on-board intelligence: powerful microprocessor and FPGA based state machine
•
three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
•
VCCP range 0..8V/1A
•
VPP1, VPP2 range 0..26V/1A
•
selftest capability
•
protection against surge and ESD on power supply input, parallel port connection
•
banana jack for ESD wrist straps connection
•
banana jack for connection to ground
Socket, pindriver
•
48-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 48-pin
•
pindrivers: 48 universal
•
VCCP / VPP1 / VPP2 can be connected to each pin
•
perfect ground for each pin
•
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
•
analog pindriver output level selectable from 1.8 V up to 26V
•
current limitation, overcurrent shutdown, power failure shutdown
•
ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)
•
continuity test: each pin is tested before every programming operation
ISP connector
•
20-pin male type with miss insertion lock
•
6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to
5V to handle all (low-voltage including) devices.
•
1x VCCP voltage (range 2V..7V/100mA)
•
programmed chip voltage (VCCP) with both source/sink capability and voltage sense
•
and 1x VPP voltage (range 2V..25V/50mA)
•
Target system power supply voltage (range 2V..6V/250mA)
•
ESD protection on each pin of ISP connector (IEC1000-4-2: 15kV air, 8kV contact)
•
two output signals, which indicate state of work result = LED OK and LED Error (active
level: min 1.8V)
•
input signal, switch YES! equivalent (active level: max 0.8V)
38