Mitterweg 25 – Via di Mezzo ai Piani 25
I
-39100 Bozen
-
Bolzano
Tel.:0471 977236
-
Fax:976525
e-mail:
http://www.elmed.it
26
6.8
Minimum speed (km/h)
If this button is activated, in automatic mode (spray programme and semi-automatic) a
minimum speed is applied. This means that if the vehicle drops below the minimum speed,
then the pressure will still be maintained for a certain time (x seconds, adjustable in the
service menu (
chapter 7.1). This means that a drop in pressure will be delayed.
The target speed entered in the spray programme / semi automatic mode (minus 0.2 km/h)
will be used as the minimum speed.
Note: When working with a minimum speed, then the minimum pressure limit function will
not be active (see point 6.7).
Warning: If using the flow sensor for regulation, only the minimum speed limit function is
available.
6.9
Pressure losses in percent
As pressure losses are possible from the pump through the valves and pipes to the
nozzles, there is a discrepancy between the pressure measured by the pressure sensor
and the actual pressure at the nozzles. This discrepancy can be compensated with this
parameter. Valid values: 0 ÷ 20% (standard = 0%).
6.10
Flow rate impulses/litre
The flow rate provides a certain number of impulses per litre. The number can be entered
here. If inaccuracies in measurement become noticeable, slight corrections can be made
here.
Valid values: 1
÷ 5,000 (standard = 1200).
Reference: This menu item only appears if a flow meter is installed.
6.11
Control with flow meter
Regulation based on the flow can be switched on and off here. If the flow regulation is
switched off, then the regulation is based on the pressure.
Notes: This menu item will only be displayed if a flow meter is installed.