Initial Setting
Initial Setting
26
Initial Setting
1
Connect power plug into you socket.
2
Connect Adapter one end to adapter in of
HMR while the other end to power cord.
3
Switch On of the mechanical switch on
the rear panel of HMR. HMR will go to
Stand by mode.
4
Press Power button on your remote
control or on front case.
HMR will be Power On from the stand by
mode. It may take about 20 seconds.
You can find that the below Initial Setting
OSD will show up
4-1
Select your language by pressing ▲,▼
buttons and Enter to execute it.
4-2
Set the current date and time by pressing
Number button and ▲,▼ button and
press Enter to execute it
4-3
Select OK and press Enter when you are
asked again. Select Cancel and press Enter
if you want to cancel the setting.
4-4
Select DHCP IP (Auto) or Fix IP (Manual)
according to your IP status by pressing
▲,▼
button and press Enter to execute it
- If you select DHCP IP (Auto), The IP address
will be set according to DHCP in your network
- Select Cancel if you do not have network
available or you do not want to set it up now.
- If you select Fix IP (Manual), Set the LAN
manually according to your network by
pressing Numbers or ▲,▼ button and press
Enter to execute it.
4-5
Select OK and press Enter when you are
asked again. Select Cancel and press
Enter if you want to cancel the setting.
• Please refer to the Network setting explanation in this
manual for the further information.
• The above OSD may not be showed on your TV when it is
connected with HDMI cable. In this case, please try again
with connecting TV through Scart or RCA cable.
NOTE
When you have finished HDD format after HDD
installation or when you power on the HMR first
time without HDD installation, you can set your
language, Time or LAN.