DS80IM39-001B
5
ENGLISH
The IM600 detector implements infrared (PIR) and microwave (MW) motion detection technology. The combination of the two
detection methods considerably reduces the false alarm rate, employing PIR for initial detection and microwaves for confirmation
before sending the alarm signal.
Part identification
1. Transmitter
LED
(red)
The LED indicator blinks to indicate that signals are being transmitted in the following
situations.
- The Learn/Test button is pressed.
- The tamper switch is actuated or reset.
- Motion is detected in Test mode.
- Motion is detected in flat battery or open tamper conditions during normal operation.
The LED does not blink if the tamper switch is closed, the battery is charged and the detector is
not in Test mode.
The LED blinks to indicate signal transmission, blinking rapidly twice upon receiving confirmation
from the panel.
The LED will blink every 4 seconds when the battery of the detector is flat.
2. Microwave detector LED (blue)
The LED lights up briefly when the microwave detector is in Test or in Microwave Test
mode.
3. IR detection LED (green)
The LED lights up briefly when the microwave detector is in IR Test mode.
4. Learn/Test
button
5. Lens
6. Battery
housing
7. Supervision
jumper
Jumper not fitted Supervision is always enabled.
8. Microwave test on/off jumper (JP3)
-
When the jumper is set to
ON
, the detector is in microwave Test mode (see
Microwave test mode
).
-
When the jumper is set to
OFF
, microwave Test mode is deactivated.
(
default
)
9. Tamper
switch
The tamper switch is activated when it is lifted and reset when it is compressed (against a
wall or a surface).
10. Microwave range trimmer
The range is indicated on the right, with the arrow pointing to the set sensitivity level:
- Turned
clockwise
it increases the detection range (up to 20 metres)
- Turned
anticlockwise
it decreases the detection range (to a minimum of 3-5 metres)
-
Default value
: set to a medium value, approximately 10 metres.
11. Tamper hole
The tamper switch must protrude from the hole on the rear cover
12. Pre-cut area
Features
Motion detection
The detector has an integrated PIR sensor and a microwave section. Motion is detected by the PIR sensor during normal
operation. When the PIR sensor detects movements, microwave detection is activated to verify the detected motion. If
both the PIR and the microwave confirm motion detection, the detector transmits the alarm signal.
Set the microwave range trimming to adjust the detection range.
When the trimmer is set to maximum, the detector has an approximately range of 12 metres and mounted at a height of
1.9~2 m.
When the trimmer is set to minimum, the detector has an approximately range of 5 metres and mounted at a height of
1.9~2 m.
Sleep Time
The detector has a “
sleep time
” of approximately 1 minute to save energy. After having transmitted a detected movement,
the detector will not transmit again for 1 minute; any further movements detected during the sleep period will extend the sleep
period by another minute. In this way, continuous movements in front a detector will not drain the battery unnecessarily.
Test mode
The detector can be set to Test mode by pressing the specific Learn/Test button. Test mode lasts for 3 minutes and restarts
from 3 minutes whenever the Learn/Test button is pressed. In Test mode, the sleep timer is deactivated and the LEDs light up
when the detector detects a movement to notify the user.
