Elkron FAP54, Installation Manual

Page: 31 / 40

FAP54 Installation 31
CONFIGURATION CIRCUIT:XX TYPE: XXXXX
TOT.PTS: XXX
XXX/SM XXX/HT XXX/OM XXX/CM
XXX/MN XXX/GS XXX/LN XXX/SH
∨
CONFIGURATION CIRCUIT:XX TYPE: XXXXX
TOT.PTS: XXX
XXX/LI XXX/PI XXX/XS XXX/TB
∧
XXX/CI XXX/IS XXX/ER XXX/??
PROCEDURE IN PROGRESS
PLEASE WAIT
N. POINTS: XXX [ESC] ABORT
CONFIGURATION STORED
[1] DELETE ALL THE ASSOCIATIONS
[2] DELETE EXPIRED ASSOCIATIONS
[ESC] BACK
PROCEDURE IN PROGRESS
********************************
[OK] FINISH [ESC]
ABORT
WARNING! THIS PROCEDURE IS VALID ONLY
FOR DEVICES CONNECTED IN PURE PARALLEL
[OK] CONTINUE [ESC] BACK
During the initialization process in auto-addressed, pre-configured or update mode, the user will be notified of the number of points
currently acquired with the following message:
At the end of initialization in auto-addressed, pre-configured or update mode, the circuit hardware configuration will be
displayed along with all the points detected on the selected line, subdivided according to quantity and type.
The type “ER” refers to devices with communication problems with the control panel or devices with duplicated
addresses.
The type “??” refers to a device whose address is recognized by the control panel, but whose type is not valid for the
control panel.
By pressing ESC
•
The configuration before initialization is restored if the pre-configured or update mode is selected.
•
The configuration is cancelled if the self-addressed mode is selected.
By pressing OK, the new configuration will be confirmed and stored.
At the end of storage, it is possible to delete all the associations or only the ones no longer valid (the same
considerations made for the configuration of all the lines are valid in this case):
If the walk addressing mode is selected, a further confirmation will be asked to the user:
If the user confirms with OK, the procedure will be started and the following message displayed:
By pressing ESC, the procedure is interrupted and the control panel cancels the circuit configuration. Cancellation is
due to the fact that the walk addressing mode changes the addresses of the devices in the field which now are
misaligned with a possible old configuration potentially restorable by the control panel.