Elkron FAP54, Installation Manual

Page: 32 / 40

32 FAP54 Installation
CONFIGURATION CIRCUIT: XX TYPE: XXXXX
TOT. PTS: XXX
XXX/SM XXX/HT XXX/MU XXX/MC
XXX/MN XXX/GS XXX/LN XXX/SH
∨
CONFIGURATION STORED
[1] DELETE ALL THE ASSOCIATIONS
[2] DELETE EXPIRED ASSOCIATIONS
[ESC] BACK
CONFIGURATION CIRCUIT: XX TYPE: XXXXX
TOT. PTS: XXX
XXX/LI XXX/PI XXX/XS XXX/TB
∧
XXX/CI XXX/IS XXX/ER XXX/??
ERROR ON CIRCUIT: XX
ERROR CODE: YYY
ADDRESS/POSITION: ZZZ
FAULT ON CIRCUIT: XX
BMP1: 01234567 BMP2: 01234567
----**-- *-*-----
TYPE: XXXX A = D--- B = D---
FAULT ON CIRCUIT MODULE XX
ERROR CODE: YYY
By pressing OK, the control panel is informed that the procedure is finished (the operator has removed and then re-
inserted each single device in the order he wanted them to be addressed).
In this last case the screen will display the devices initialized up to that moment, subdivided per type and number.
By pressing ESC the configuration is cancelled. By pressing OK the new configuration is confirmed and stored.
At the end of storage, it is possible to delete all the associations or only the ones no longer valid:
During the initialization procedure, regardless of the type of selected initialization, a module fault could occur. In such
a case, the procedure will be interrupted and the following message will be displayed with:
•
The number of the circuit connected to the line affected by the fault
•
The error code (please, refer to Appendix 1 for further details)
If a procedure error occurs during the initialization procedure, it will be interrupted and the following message will be
displayed with:
•
The number of the circuit connected to the line affected by the fault
•
The error code (please, refer to Appendix 2 for further details)
•
The address or physical position of the device which has generated the error (depending on the procedure,
this information could be present or not and, in the case it is present, its meaning is strictly related to the
procedure)
If an error related to the detection line (concerning specifically the field) occurs , the following message is displayed
(please, refer to appendix 3 for further details):