Elkron FAP54, Installation Manual

Page: 5 / 40

FAP54 Installation 5
1.2 SICUREZZA PRODUCT SAFETY
•
The control panel shall be installed in a fixed way.
•
Do not position the control panel next to liquids or in an environment with a high level of humidity.
•
Do not let any liquid or foreign bodies penetrate inside the equipment.
•
Do not obstruct ventilation grilles.
•
Do not expose the control panel to sunrays or place it next to heat sources.
1.3 PARTICULAR PRECAUTIONS
It is absolutely necessary to observe the order of the installation and connection instructions described in the present
manual. Check the indications on the identification plate: they shall correspond to your power network and electric
consumption.
1.4 DECLARATION OF THE MANUFACTURER
The control panel described in this manual has been developed according to the quality, reliability and performance
criteria used by ELKRON.
Every component can operate according to the EN54-2 and EN54-4 standards.
1.5 LIST OF OPTIONS WITH REQUIREMENTS
7.8 Output to fire alarm device
7.9
Output to fire alarm routing equipment
7.11 Delay to outputs
7.12 Co-incidence detection
8.3 Fault signals from points
8.9
Output to fault warning routing equipment
9.5 Disablement of addressable points
10 Test condition
1.6 COMPLIANCE WITH EN54-2
In order to be compliant with the EN54-2 standard, the following rules must be observed:
1. Each manual push button and fire detector used in the control panel must be associated to fire alarm detection
zones
2. Connect up to 32 points to each circuit configured in OPEN mode
3. Connect up to 128 points (each point is a short circuit isolator) to each circuit configured in LOOP mode