Elk Products ELK-M1G Installation And Programming Manual Download Page 36

Page: 36 / 72

M1G Installation and Programming

Page 36

Menu 07 - Global System Definitions

(continued)

Global Sys Definitions

Description of Option

Allows Output 2 to be converted from a siren driver into a voltage only output. If set to
“No” the control produces alarm sounds for use with 8 Ohm speakers. If set to “Yes” the
control will p12 Volts for use with self-contained sirens or bells. Default is No.

Ordinarily, Outputs 1 & 2 activate immediately on alarms. However, Output 2 can be time
delayed up to 255 seconds. Using Output 1 strictly for interior sounders and Output 2 for
outside sounders, a false alarm will be heard inside first, giving the user time to disarm
before any outside sounders are activated. A “good neighbor” feature. Default is 000.

†

Output 2 can be set to alarm only once per armed cycle for burglary type alarms. This

feature is intended for noise abatement. The dialer will continue to transmit all alarms that
may occur. THIS ONLY LOCKS OUT AUDIBLE FROM OUTPUT 2.

The control must be set to auto answer an incoming call in order for Telephone Remote
Control or the Remote Programming (RP) to be accessed remotely. The range of rings
can be set from 1 to 15. A value of “0” disables auto answer.

A Yes enables faster connection from an outside telephone. It works as follows: Call the
control and hang up after 1 or 2 rings. This starts a 45 second timer. Call the control a
2nd time

during this 45 second time and

the control will answer on the first ring. In some

cases this Ring/Hang/Answer option may be the only way to get around telephone
company provided answering services.

Option 29 MUST also be set!

NOTE: If an on-site answering machine picks up, the RP software and the control
will automatically attempt to override the machine using tone sniffing methods.

†

If this option to Yes ONLY when an ELK-M1TWI Two Way Listen-In interface is

installed. This enables the correct software commands and procedures to make the two
way functional. Refer also to the instructions that are shipped with the ELK-M1TWI

If Two Way is enabled, this timer provides a window for the CS to enter * 55 * and activate
two way listen-in by holding the phone line off-hook for 01 to 60 seconds after a kissoff.
Upon hangup, this timer re-starts to provide a window for the CS to callback and initiate
two way. Control will answer an incoming call on the first ring. Enter 00 to disable.

Allows the Central Station alarm verification by suspending (holding) new alarms after the
initial alarm kissoff. The phone line is kept free for this time period. The time value can be
from 001 to 255 seconds. Long time periods are not recommended. Enter 000 to disable.

This location is used to set the “revert back to” baud rate for the on-board RS-232 serial
port which is Port 0. The available selections are: 0 or 1=300 baud, 2=1200, 3=2400,
4=4800, 5=9600, 6=14400, 7=19200, 8=38400, and 9=115200. Factory default: 115,200.

The control can transmit ASCII data via it’s RS-232 port to automation types of equipment.
The ELK ASCII Protocol document is available upon request. This first option sets the
control to transmit all event log information immediately as it occurs.

This option sets the control to transmit zone status changes immediately as they occur.
The ELK ASCII Protocol document is available upon request.

This option sets the control to transmit output status changes immediately as they occur.

123456789012345678901234567890121234

G29:=00 Rings

Until AutoAnswer

123456789012345678901234567890121234