www.ELITETOOLS.co
Keep Working
When the blade is worn and small, as shown in the figure (previous page) place a small bracket between
the workpiece and the clamp (A) and (B). This allows the cutting blade to use less lead.
USE A SMALLER SUPPORT THAN THE WORKPIECE
4. Quick lock vice
The maximum width of the vice for us in our factory is 138 mm (187 mm: HC -16H). To widen the fastener
more than 138 mm (187 mm: HC -16H), loosen the two screws to move them as far as the dotted line
indicates. The maximum width can be 176 mm (237 mm: HC -16H).
5. Portable vice powers system
Secure the workpiece, place the lever on the portable vice resting the table on the screw, put the steering
forward and turn the crank handle, then the portable vice moves to secure the workpiece.
After completing the desired cut loosen the screw just a little and remove the lever inside the screw by
turning it back. Then pull the handle on the crank to remove the vice clip.
9
Summary of Contents for CS1425
Page 33: ...www ELITETOOLS co Keep Working...
Page 34: ......
