www.ELITETOOLS.co
Keep Working
2. Cable extension
The extension cable can be used for a remote power supply. Use an extension cord of the appropriate
length and thickness to obtain satisfactory electrical current. A very long or thin cable can result in a high
voltage shock and weaken the power of the motor. Use an extension cord as short as possible.
A DAMAGE TO THE CABLE MUST BE REPLACED OR REPAIRED IMMEDIATELY.
USE A DOUBLE INSULATED CABLE FOR THE EXTENSION CABLE
3. Work Place
Check the conditions of your work area
4. Power Supply
Be sure to verify the required voltage output and the voltage usage marked on the board. Use 110V / 120V
only on the tool, with a 220V / 230V / 240V output can result in damage to the cutting disc and / or tool due
to accidental high speed in the motor.
5. Switch
When the plug is connected with the power supply turned on, it could suddenly cause the tool to rotate and
cause an accident. Verify that the switch state returns to its original state after pressing (turning it on)
drop it.
6. Verify that the cutting disc and each part are securely assembled.
The cutting disc is firmly installed with the main frame of the saw for easy use.
For your safety, hold the bolt to install the cutting disc with the wrench (17mm). Check that each part is tight-
ly tightened.
7. Departure
When there is a noise when plugging in or the plug can be easily removed, or has a repaired outlet. This
can cause an overheating accident.
8. Always do a controlled cut test before using the machine.
Before using the machine, check grooves or damage to the cutting disc. Always perform a test to verify the
condition of the test. (For safety, do it after replacing the disc cut: for 3 minutes, and before operating the
machine for 1 minute).
110V / 120V
nominal cross section
for conductor
maximum
length
1.25 mm
2
3.5 mm
2
2 mm
2
20 m
50 m
30 m
5
Summary of Contents for CS1425
Page 33: ...www ELITETOOLS co Keep Working...
Page 34: ......
