Elipson Infinite A1000, User Manual

Page: 24 / 32

24
EN
Phase Setting Select
The “Phase” setting is used to adjust the phase/
polarity of the subwoofer to provide the best
summing to the main speakers. The physical
placement and distance of the subwoofer
in relation to the main speakers may result in
unwanted cancelation of some of the bass and
can be compensated for by adjusting the phase
setting.
The phase setting can be adjusted while listening
for maximum or best bass performance or by
using a real time analyzer and measuring the
actual response of the system as a whole. The
phase adjustment is in 45 degree steps from 0 to
315 degrees.
Use Left and Right buttons to set and Menu to save.
Auto Off Setting
The “Auto Off” setting allows the amplifier to turn on
and off based on the presence of an audio signal.
When set to “OFF”, the function is disabled and
the amp stays on constantly. When set to “ON”,
the amplifier is controlled by the presence, or
absence, of audio signal on the input jacks. When
an input signal is present, the amplifier will turn on
immediately. Once the signal stops, the amplifier
will turn off after the selected time duration. There
are duration settings from 5 minutes to 30 minutes
in 5 minutes increments. Typically this is used with a
receiver which does not have a 12V trigger.
Use Left and Right buttons to set and Menu to save.
User EQ Setup*
In “User EQ” mode, the user can adjust the levels
on nine 1/3 octave bands from 20 Hz to 125 Hz.
(20, 25, 31, 40, 50, 63, 80,100,125 Hz) by using the
Left/Right buttons. At each frequency, there is a +3
to -6dB level adjustment in 0.5dB steps and can be
adjusted by pressing the Up/Down buttons.
* Only available in User mode.